ARJO Huntleigh Healthcare
AURA Quick Reference Guide
Quick Reference Guide
2 Pages
Preview
Page 1
AURA® QUICK REFERENCE GUIDE (
)
Comfort Control Knob
Filter (on rear)
Run/Standby Indicator Low Pressure Indicator Power Fail Indicator
Aura
™
-
Suspension Hook !
+
Air outlets Fuse Holder Run/Standby Switch Setting Up Instructions On Rear
!
+
Run/Standby Switch & Alarm Reset
Switches the pump on and off. An internal battery will activate an audible and visual alarm if the power supply is interrupted prior to switching off. Examples are mains lead removal and power failure. Once an alarm condition has been resolved, the pump can be reset by switching the pump to standby and back to run again using the Run/Standby switch on the side panel.
Run/Standby Indicator
The green Run/Standby indicator is illuminated when the pump is running.
Low Pressure
The red Low pressure indicator will flash whenever the pump detects low pressure within the cushion. An audible alarm will sound. The pitch of the alarm will increase at 60 second intervals. The indicator will extinguish once normal pressure is reached. Check the tubeset is connected properly.
Power Fail
The red Power Fail alarm indicator will start flashing when a mains power failure has been detected by the pump. An audible alarm will sound until power is resumed or the pump is switched off using the Run/Standby switch. The pitch of the alarm will increase with time. The indicator will remain illuminated until the pump is reset using the Run/Standby switch.
Comfort Control
The seat cushion cell pressure can be manually adjusted for patient comfort using the dial on the pump face.
Installation
Aura
Quick Start: Place the Aura seat cushion on top of the chair surface. From a standing position in front of the chair and facing it, ensure that the cells are uppermost, the tubeset appears from the front right corner of the cushion and the cells are in a horizontal position across the chair.
™
+
!
Secure the seat cushion to the chair surface using the fixing straps provided.
Aura
If the chair is of the closed side type with a removable cushion, fix the Aura seat cushion as shown.
-
™
! +
Caution: Do not use the seat cushion without a foam cushion beneath it. To complete the seat cushion installation: Zip the protective cover over the cushion. Ensure that the Huntleigh logo is uppermost and at the front of the cushion. Installing the pump:
Aura
™
! +
Position the pump feet down on any convenient horizontal surface or alternatively suspend from the chair frame by means of swing out hooks.
Connect the male and female air feed tubes into the appropriate outlets on the pump unit. Push connectors in until they click. Ensure that the air feed tubes are not “kinked” or twisted. Insert the mains power plug into a suitable mains power socket.
MRF-118
When the Aura pump is switched on at the mains supply all indicators will momentarily flash. Press Run/Standby switch on the side of the pump. Allow approximately 2 minutes for the seat cushion to inflate fully. Once the patient is on the seat cushion, adjust the cell pressures using the comfort control dial according to the patient's preference.