Quick Reference Guide
2 Pages

Preview
Page 1
Symbols
The filters patient air inlet filters are located inside a magnetic filter holder at the back of the ventilator. Washable Filter (grey): Replace at least once a year, wash at least once a week. Disposable Filter (white): Replace at least every four weeks, or more often in high pollution or pollenrich environments.
SYMBOL
Vivo 1/2/3
DESCRIPTION SD card inserted and working
Quick Reference Guide Doc. 007613 En rev Y-2 2019-11-05
Nurse call connected Remote alarm connected SpO2 connected Humidifier activated Heated circuit activated “Clock radio wake up” activated All alarms shut off Powered by mains Powered by external DC Battery status (Vivo 3 only)
ENGLISH
7 321820 076130
Replace the Patient Air Inlet Filters
Quick Reference Guide This is not a complete guide for the Vivo 1/2/3. See your manual for complete instructions.
Connect the Power Cord Insert the power cord and turn it clockwise to lock it.
Accessory Connectors
Start/Stop Treatment
The SpO2 module can be connected to the ventilator (item 1) using the SpO2 adapter cable or to the accessory box. The accessory box can also be used for connecting the remote alarm unit or the nurse call cable.
1.
To start treatment first press and hold the On/Off button on the front panel.
2.
Release the On/Off button when the progress bar is filled.
1.
To stop treatment and enter standby mode first press and hold the On/Off button on the front panel.
2.
Release the On/Off button when the progress bar is filled. Do one of the following: Press the Mute Alarm button (a), or press Ramp (b).
1
b a
Switch On/Off Press the On/Off button.
Connect the Patient Circuit 1.
Connect the patient circuit to the patient air outlet on the ventilator.
2.
If connecting a new or modified patient circuit, perform a pre-use test (available from the Others section).
3.
Connect the other end of the patient circuit to a leakage port or to a patient interface with integrated leakage port.
Oxygen Connection (Accesscory) • O2 must be turned off when the Vivo 1/2/3 is not in operating mode! • It is recommended to monitor the oxygen concentrations. • Oxygen flow must not exceed 30 l/min. 1.
Mount the oxygen tube to the connector.
2.
Connect the oxygen tube. A click sound is heard when the tube is properly attached.
Disconnect: 1. Turn off the oxygen source. 2. Press the release button to disconnect the oxygen tube. 3. Remove the tube.
3.
a
b