Deltec
Model 3000 Pump Training Guide
Training Guide
2 Pages
Preview
Page 1
Training Guide Model 3000 Pump Primary Operation Invert the 3-chambered cassette and prime the set. Hang solution so the bottom of the drip chamber is at least 6-12 inches above the pump. Open the door. Place cassette in pump with flat side facing you. Slide Safety Clip up and insert into slot. Close the door. Open the roller clamp.
Rate
1 4
Volume to be infused
RATE: Enter desired rate.
SILENCE: Press Silence to OR HOLD: Press Hold to turn turn off alarm. Alarm will off alarm and stop pump. re-occur after 6 minutes.
Silence
OR
Hold
When volume to be infused reaches zero, pump automatically switches to KVO rate.
OTHER PUMP FUNCTIONS
Total Volume
Occlusion Alarm Setting
Keeps total of all infusions until cleared.
Medium setting is automatic. Select high or low setting if instructed.
2 3
VOLUME TO BE INFUSED: Enter desired volume.
RUN
Run
TO REPEAT SAME INFUSION
Volume to be Infused
Run
Press twice to reset to previous setting.
Press Run.
Over for Secondary Operation
Training Guide Model 3000 Pump Secondary Operation If using pump for automatic piggybacking, the primary line must have a check valve set. The pump is running on primary. Using an 8-inch hanger, lower the primary bag. The primary drip chamber must be 6-12 inches above pump (raise pole if necessary). Elevate the secondary bag.
Secondary
Hold
When secondary Volume to be Infused reaches zero, an audible alert sounds briefly and primary flow resumes at programmed primary settings.
5
HOLD: Press hold if pump is running in primary rate.
1
RUN
Run
Secondary
2 4
VOLUME TO BE INFUSED: Enter the secondary volume.
Volume to be Infused
3
RATE: Enter the secondary rate.
SECONDARY
Rate
Visit our web site at www.deltec.com
Deltec SIMS Deltec, Inc., St. Paul, MN 55112 U.S.A.
©1999 SIMS Deltec, Inc. All rights reserved. Printed in U.S.A. 10/99 19997
Customer and Clinical Services: 1 (800) 426-2448 WARNING: This Training Guide should be used by clinicians only. Do not permit patients to have access to this guide, as the information would allow access to all programming and operating functions. Read the entire Operator’s Manual before operating the Model 3000 pump. Failure to properly follow warnings, cautions and instructions could result in death or serious injury to the patient. If the pump is dropped or hit, inspect it for damage. Do not use a pump that is damaged or is not functioning properly.