ERBE
ERBEJET 2 Quick Guide May 2021
Quick Guide
2 Pages
Preview
Page 1
QUICK GUIDE ERBEJET® 2 for surgical applications !
This quick guide is no substitute for briefing and user manual. This quick guide does not include any safety notes. Make yourself familiar with the safety notes in the user manuals.
Necessary operating steps 1 Inserting the suction bag
2 Connecting the vacuum hose
5 Selecting the program
8 Attaching the suction hose to the suction container
1. Use the selection buttons to select a program. 2. Confirm using the OK selection button.
6 Connecting the applicator
connector and pump cartridge
1. Attach the adapter onto the connection port for the suction hose. 2. Attach the suction hose onto the adapter.
9 Connecting the NaCl solution to the pump cartridge
ESM 2
Connect the applicator connector and pump cartridge. Use aseptic techniques to do so.
3 Switching on ERBEJET 2
7 Inserting the pump cartridge 1. Connect an infusion set to a sterile NaCl solution. Use aseptic techniques to do so.
4 Switching on ESM 2 1. Wait until the ERBEJET 2 display shows Please insert new cartridge!. 2. Slide the pump cartridge into the pump shaft. The pump cartridge must audibly click into place.
2. Open the roller clamp. 3. Fill the infusion tube until it has been fully vented. 4. Close the roller clamp.
HYDROSURGERY
80114-381
2017-02
Optional operating steps
15 Changing the suction mode
12 Changing the effect
5. Remove the protection cap from the pump cartridge and infusion tube. Use aseptic techniques to do so. 6. Connect the pump cartridge and infusion tube. Use aseptic techniques to do so.
13 Changing the suction strength
16 Replacing the applicator
7. Open the roller clamp.
10 Priming the pump cartridge
14 Changing the run-on time
1. Wait until the ERBEJET 2 display shows Prime. 2. Direct the applicator towards a cloth.
The pump unit is intended for the treatment of one patient. The applicators can be replaced any number of times during the treatment of this one patient. Press the release mechanism to release the applicator. Use aseptic techniques when you replace the applicator.
3. Press the START selection button. 4. Verify whether the suction hose of the pump cartridge fills with the NaCl solution. The priming process can take up to 20 seconds.
11 Conducting a function test 6WHULOHDUHD
1. Direct the applicator towards a cloth. 2. Activate the footswitch. The water jet is emitted.
© Erbe Elektromedizin GmbH
Contacts worldwide: see erbe-med.com
Hotline Germany: +49 7071 755 123