CARESCAPE Monitors Addendum to Users Manual Loss of data 2nd Edition June 2018

English Addendum for CARESCAPE monitors’ user’s manual 2110369-001 2nd edition 2018–07–30 © 2018 General Electric Company. All rights reserved. All specifications are subject to change without notice.

GE Healthcare Finland Oy Kuortaneenkatu 2 FI-00510 Helsinki, Finland Tel: +358 10 39411 www.gehealthcare.com

Intended use of this addendum This addendum must be used in conjuction with the monitor’s user’s manual for software version 1 and software version 2.

Loss of data CAUTION LOSS OF DATA. Should the monitor at any time temporarily lose patient data, the potential exists that active monitoring is not being done. Close patient observation or alternate monitoring devices should be used until monitor function is restored. If the monitor does not automatically resume single-parameter operation within 60 seconds or full monitoring in 90 seconds, power cycle the monitor by turning it off and then on again. If monitoring is not restored, disconnect the network cable from the monitor’s Network IX/MC ports and keep the patient under close observation. Once monitoring is restored, you should verify correct monitoring state and alarm function.

Restarting after network overload In rare situations when a prolonged network overload occurs and the CARESCAPETM Monitor Bx50 on the network does not resume normal functionality within 90 seconds, take the following actions. 1.

Temporarily switch the monitor from central monitoring to local (bedside) monitoring: a. Disconnect the LAN cables from the IX/MC ports on the back panel of the monitor. b. Keep the patient under close observation and continuous surveillance at the bedside monitor.

2.

2110369-001

Contact your IT department or other appropriate personnel in your facility responsible for the network.

General Electric Company

1