Kangaroo ePump User Guide (Feed & Hydration Mode)

Kangaroo™ ePump Enteral Feeding Pump

User Guide (Feed & Hydration Mode) Pump set loading procedure. 1

2

3

4

5

6

Locate power button on lower right hand corner of control panel. Press to turn pump on.

Confirm if you want to KEEP or CLEAR any prior pump settings.

With pump display facing you open blue door at top of pump.

Grasp finger tab on valve and insert valve into valve slot on the left.

Grasp black ring retainer, and gently wrap tubing anticlockwise around rotor. Pull up retainer and insert into slot.

Close blue door. Display should read SET LOADED.

Power down procedure Locate power button on lower right hand corner of control panel. Press and hold power button until the pump displays turns off. Alarm code information.

Problem with pump Pump left in Hold set tubing around for more than the rotor. 10 minutes. Ensure silicone Press CONTINUE tubing is correctly followed by RUN to start pump running or loaded around rotor. power down pump.

Obstruction in line Feed container downstream from empty or obstruction pump. in the line upstream from pump. Check for kinked or blocked tubing below Check for kinked pump and rectify tubing or obstruction in line above pump or attach new/refilled feed container.

Water container Programmed feed empty or obstruction has been delivered. in the line Power down pump. upstream from pump. Check for kinked tubing or obstruction in flush line above pump or refill flush container.

Black retainer ring (MISTIC) is not properly loaded in MISTIC pocket. Ensure pump set is correctly loaded.

Battery must be charged immediately. Plug power cord into AC outlet.

General error - see pump manual. Send pump for service.

Set priming and pump programming procedure. 1

2

3

4

5

Press PRIME PUMP followed by AUTO PRIME to automatically prime or HOLD TO PRIME to manually prime both feed and flush lines. Press DONE when complete.

Press ADJUST FEED followed by FEED RATE to adjust hourly delivery rate.

 ress buttons on left to program hourly P feed rate. Press ENTER to confirm rate.

Press FEED VTBD to program feed Volume To Be Delivered if desired.

Press buttons on left to program volume of feed to be delivered. Press ENTER to confirm rate, followed by DONE to return to main screen.

6

7

8

9

10

46 cm

P  ress ADJUST FLUSH to program flush volume and interval.

Press FLUSH VOLUME to program Press buttons on left to program volume Press buttons on left to program flush volume. Press FLUSH INTERVAL to of flush to be delivered. Press ENTER to flush interval. Press ENTER to confirm program interval between each flush. confirm volume. interval, followed by DONE to return to main screen.

Press RUN to commence feeding regime. In order to achieve proper accuracy the bottom of the feeding set container must be 46 cm above the top of the feeding pump.

For complete operation information please refer to KangarooTM ePump enteral feeding pump operation and service manual. * Important Note. Kangaroo™ ePump will automatically flush an additional 25mL of water after completing the programmed delivery of formula, as long as at least one flush had occured during formula delivery.

Cardinal Health Australia.

Level 2, 5 Eden Park Drive, North Ryde NSW 2113. © 2021 Cardinal Health. All Rights Reserved. CARDINAL HEALTH, the Cardinal Health LOGO and ESSENTIAL TO CARE are trademarks of Cardinal Health and may be registered in the US and/or in other countries. All other marks are the property of their respective owners. 1930 ref # MSCR-81

cardinalhealth.com.au