Blender Buddy Assembly Instructions & Instructions for Use Rev B

Maxtec, Inc. 6526 South Cottonwood Street Salt Lake City, Utah 84107 USA Authorized Representative:

EC REP

QNET BV Hommerterweg 286 6436 AM Amstenrade The Netherlands

TEL (800) 748.5355 FAX (801) 270.5590 www.maxtecinc.com

INSTRUCTIONS FOR USE 1. Attach the DISS female fitting A of the Blender Buddy to the DISS male fitting B on the left side of the Precision Medical Blender E . 2. Attach flow meters C to the male DISS fittings D on the front of the Blender Buddy. 3. Supply gas to the blender and check for leaks and proper function.

WARNINGS
» Carefully read instructions provided with flow meters, as well as this insert, before use. » For use with air/oxygen blenders only. » Max pressure is 100 psi. » Do not use lubricants on o-rings. » Check for leaks after assembly. » Not for use in MRI Environments. » Maxtec assumes no responsibility for any damage or injury caused by improper installation, assembly or use of this product. » Replace EPDM o-rings during recommended blender rebuild. Use Maxtec approved o-rings. » This product should only be used under proper supervision of a healthcare professional. » If components are damaged or missing, contact your dealer immediately. » DO NOT use substitute parts. » Clean often using a cloth moistened with 65% isopropyl alcohol/water solution or germicidal wipe. » Follow all recommendations provided in the manual for the connected blender.

WARRANTY » 2-year limited warranty on manufactured defects.

Authorized Representative in the EC REP European Community

Manufacturer LOT Lot code/Batch code

REF Catalog Number

Attention, consult accompanying documents

For use with the following models: Precision Low Flow Blender (PM5300)

1



2

 

2

866.4.Maxtec

 

www.maxtecinc.com