MAXTEC

MaxVenturi Additional Patient Interface Guide - Fisher & Paykel Rev A

Patient Interface Guide

2 Pages

Instructions For Use Additional patient interface systems have been identified which are sufficiently non-restrictive for use with the MaxVenturi. The flow rates for these patient interface systems differ from flow rates of the Fisher & Paykel heated humidifier and Optiflow patient interfaces. The lettered scale on the flow meter allows the user to determine the flow for various alternate patient circuits according to the table on the other side of this card. The actual flow rate for each alternate patient circuit can also be found on the Flow Look up Card attached to the device. Locate the patient interface and delivery circuit in the left hand column. Find the corresponding flow rate by reading to the right under the corresponding column A through F. The lettered columns correspond to the lettered graduations on the flow meter. See section 2.2.3 of the User Manual for specific details on approved patient circuits and interfaces.  R211P23 REV A  WARNING: » Ensure the delivery circuit is not kinked or occluded. » Use only with approved humidifier, circuit and patient interface*. »W  ait 15 seconds after a change in oxygen to allow oxygen signal to stabilize before reading. »D  o not humidify inlet air. »D  o not deliver aerosol medication to the air inlet. »D  o not remove oxygen inlet valve or the attached fittings. »D  o not operate device with oxygen sensor out of its port. »N  ot intended for use life sustaining therapy. »N  ot for use in an MRI environment. »U  se only Maxtec replacement sensors. *See section 2.2.3 for a list of approved humidifier, circuit and patient interface. Maxtec Inc., 6526 South Cottonwood Street • Salt Lake City, UT 84107 Tel 801.266.5300 • Fax 801.270.5590 • Toll Free 800.748.5355 • www.maxtecinc.com
File Type: PDF
File Size: 58.5 KB
File Name: MAXTEC - R211P23 - MaxVenturi Additional Patient Interface Guide - Fisher & Paykel Rev A.pdf

By clicking Download you are confirming this is the correct document for your purposes
and that you agree to our Terms & Conditions