Scope Buddy Quick Start Guide

Refer to User Manual for more detailed instructions

1

IN Connection

2

OUT Connection

3

ATTACH Endoscope

• Connect Fluid Intake Line to ‘IN’ port and place filter screen in diluted detergent solution.

• If using DSD Extension Line, connect to ‘OUT’ port and to DSD hookup.

• Connect endoscope to Scope Buddy tubing Universal Extension Line or DSD hookup.

• If using Universal Extension Line, connect to ‘OUT’ port and to Universal 2, 3 or 4-way Adapter.

• Ensure endoscope is fully immersed in fluid filled sink.

FLUSH Endoscope

4

• Use ▲ or ▼ arrows to set flush time. • Press “Start/Stop” to begin cycle. Refer to Scope Buddy Rinse Matrix Verify fluid exits all channels. for specific endoscope flush times. • Upon completion, tone sounds and Add 5 seconds if tubing unprimed. display flashes 000.

AIR PURGE Endoscope

5

• Remove Fluid Intake Line from solution and place on counter.

• Press “Start/Stop” when fluid no longer exits endoscope.

• Press “Start/Stop” once to reset time; a second time to begin purge cycle.

DETACH Tubing

RINSE Endoscope

6

• Place Fluid Intake Line in clean water. • Press ▲ or ▼ arrow to reset time and “Start/Stop” to begin cycle.

7

• Disconnect DSD hookup from DSD Extension Line, or disconnect endoscope from Universal Extension Line

• Repeat step 5 to purge endoscope. Manufactured in the USA by:

www.minntech.com/medivators ©2008 Minntech Corporation, All Rights Reserved. 50096-814/A

REPROCESSING SYSTEMS A Minntech Corporation Business Group