OLYMPUS
Electrosurgical Generator
ESG-410 Electrosurgical Generator Foot switches, neutral electrodes and procedures Quick Reference Guide Sept 2020
Quick Reference Guide
2 Pages
![Page 3 of 4 ESG–410 Foot switches, neutral electrodes and procedures Quick Reference Guide Foot switches 1. Connect a wired foot switch or a receiver to the foot switch sockets on the rear panel of the ESG-410. Wireless Wired Rear panel of ESG-410 Receiver Available foot switch types Foot switch indicators Does the receiver match the footswitch? There is one receiver for every foot switch. The number stickers on both should be the same. 2. Tap the foot switch button on the home screen. 3. Tap the socket pane that requires a foot switch. Highlighted socket pane 4. Once the selected socket is highlighted, tap the desired foot switch under [Select foot switch]. Unassigned socket pane Socket with an assigned foot swtich Indicators of connected foot witches No foot switch connected](https://images.bioclinicalservices.com.au/59fj5wt376gb0k0bywsvy1dktgkk/320w/OLYMPUS%20-%20W9920719%2001%20-%20ESG-410%20Electrosurgical%20Generator%20Foot%20switches%2C%20neutral%20electrodes%20and%20procedures%20Quick%20Reference%20Guide%20Sept%202020%20-%202020-09.png)
Preview
Page 1
Page 3 of 4
ESG–410
Foot switches, neutral electrodes and procedures Quick Reference Guide
Foot switches 1. Connect a wired foot switch or a receiver to the foot switch sockets on the rear panel of the ESG-410. Wireless
Wired
Rear panel of ESG-410
Receiver
Available foot switch types
Foot switch indicators
Does the receiver match the footswitch? There is one receiver for every foot switch. The number stickers on both should be the same.
2. Tap the foot switch button on the home screen. 3. Tap the socket pane that requires a foot switch.
Highlighted socket pane
4. Once the selected socket is highlighted, tap the desired foot switch under [Select foot switch].
Unassigned socket pane
Socket with an assigned foot swtich
Indicators of connected foot witches
No foot switch connected
Page 4 of 4
Neutral electrode setup screen The [Neutral electrode setup] screen provides information on types and states of neutral electrodes.
Contact quality will be shown for split type/dual pad neutral electrodes. Contact quality is not known for non-split type/single pad neutral electrodes and won’t be indicated.
Is the patient a baby? Turn on baby mode to receive a warning message when the current flow through the neutral electrode pad is too high.
Procedure screen To load a saved procedure, select a procedure from the list. To save the current settings, tap [Save]. This will save: - Modes, power, effect - Foot switch assignment - Autostart state - Baby neutral electrode state
Manufacturer: Olympus Winter & Ibe GmbH Kuehnstr. 61 22045 Hamburg, Germany
Refer to the instructions for use.
W9220719_01, en
2020-09-22