Model TT490-15 Series Instruction for Use Oct 2014

Pre-use Set Up •

Adjust the flowmeter 1 to minimum (fully clockwise) and the adjustable pressure valve control 2 to minimum (fully counter clockwise). • Connect the flowmeter gas hose 3 to the external gas supply. • Check that the pressure gauge 4 reads zero (inside the black band). If not, then the Tom Thumb requires servicing. • Connect the NeoPEEP patient circuit 5 to the Tom Thumb outlet using the adapter 6 . Do not apply to the patient at this stage. • Set the flowmeter to the required flow rate, up to the maximum of 15 l/min. • Occlude the patient opening of the ‘T-Piece’ 7 and the PEEP* valve outlet 8 to create an air tight seal. • Turn the adjustable pressure valve control 2 until the required PIP* is set, as shown by the pressure gauge 4 . • Uncover the PEEP valve outlet 8 . Adjust the PEEP setting by adjusting the PEEP control cap 9 on the NeoPEEP patient circuit - until the reading on the pressure gauge 4 indicates that the correct PEEP has been achieved. • Connect the ‘T-piece’ 7 to a suitable resuscitation mask 10 or to the patient’s E.T. tube. • The Tom Thumb is now ready for use. * Note: PIP = Peak Inspiratory Pressure PEEP = Positive End Expiratory Pressure

For use by qualified trained personnel only. Recommended gas inlet pressure of 4 bar. Use flow rates within the range of the flowmeter. Adjust outlet pressure after altering the flow rate. Do not attempt to adjust the safety valve 11 . 1cm WG = 1cm H2O = 0.981mb Gauge ± 1.6% FSD, Flowmeter ± 10% of the indicated flowrate or ± 0.5 LPM whichever is greater

! ! ! ! ! ! !

3

8 9

2 7 10 1

6 = 0120139 Standard, reusable 0120140 Standard, disposable 0120141 Reduced outlet, reusable

6 11

4

5

Guidelines for Use During Resuscitation 1. Follow the pre-use set up procedure and set the required flow rate and outlet pressures; as defined by the hospital’s protocol for resuscitation. Ensure pressures are checked prior to administering gas to the patient. 2. Apply the mask to the patient and cover the ‘T-Piece’ PEEP valve outlet to inflate the patient’s lungs at the set flow rate and pressure. 3. Uncover the ‘T-Piece’ PEEP valve outlet and allow the patient’s lungs to deflate. 4. Repeat steps 2 & 3 as necessary during the resuscitation of the patient (follow the hospital’s protocol for resuscitation). Cleaning and Care Clean using a clean cloth dampened with cleaning solution approved by the hospital. The Tom Thumb is not intended to be sterilized. Do not autoclave. Do not allow moisture or foreign matter to enter the safety valve 11 or the adjustable valve 2 . Damage will occur if the Tom Thumb is subjected to severe mechanical shock or is dropped. Servicing The Tom Thumb should be serviced every 12 months; or if the pressure gauge does not read zero (outside of the black band) with no flow, or if the unit’s accuracy is in doubt. Viamed recommends that the gas hoses should be checked every 3 months, and replaced every 4 years as a minimum.

Patient Circuit Parts Single use Silicone Round Facemask Part Number

Model Ref.

Size

Qty

3210073

200600D

0

Pack of 20

3210068

200550D

0.5

Pack of 20

3210074

200500D

1

Pack of 20

Single use NeoPEEP Neonatal Resuscitation Circuit Part Number

Model Ref.

Length

Qty

3210013

800100/BLUE

1.0m

Pack of 20

3210014

800100/BLUE includes adapter 0120141

1.0m

Pack of 20

3210023

800150/BLUE

1.5m

Pack of 20

Reusable Circuit Adapters (single units) Part Number

Model Ref.

Size

Usage

0120140

PF 1515

15mm I.D. - 15mm I.D.

Reusable

0120141

KC 2124

15mm I.D./22mm O.D. 15mm I.D./22mm O.D.

Disposable

0120139

PF 1510

15mm I.D. - 10mm I.D.

Reusable

Warranty Viamed warrants that the goods are free from defects of manufacture, for a period of one year from the date of shipment from Viamed. Liability shall be limited solely to the replacement and repair of the goods and shall not include shipping costs or other incidental damages. This warranty is null and void if any items are subjected to misuse, negligence, accident; or repairs - other than those performed by Viamed or an authorized service centre. These instructions apply to the following Tom Thumb TT490-15 Series. Part Number

Tom Thumb with 15 l/min Flowmeter

0310027

1m air hose and Medirail mounting

0310029

3m air hose and Medirail mounting

0310032

1m oxygen hose and Medirail mounting

0310034

3m oxygen hose and Medirail mounting

0310072

1.5m oxygen hose with Dräger fitting and Medirail mounting

0310074

3m oxygen hose with Dräger fitting and Medirail mounting

0310075

1m oxygen hose with pole mount

0310076

3m oxygen hose with pole mount

0310082

1m oxygen hose with reduced outlet and Medirail mounting

0310092

1m oxygen hose with top mounted gauge and Medirail mounting

*0390007*

Viamed Limited � 15 Station Road � Cross Hills Keighley � West Yorkshire � BD20 7DT � United Kingdom Tel: +44 (0)1535 634 542 Fax: +44 (0)1535 635 582 Email: [email protected] Website: www.viamed.co.uk

ISO 13485:2003

Part Number: 0390007 Date: 10/14 003