Quick Reference Guide
2 Pages
Preview
Page 1
AutoPulse® Quick Reference Guide
For Adult (>–18 years) Non-Traumatic Cardiac Arrest Maximum Patient Weight 300 lbs.
• Remove ALL clothing from torso (both front and back) to ensure skin-to-platform contact • Align armpits onto yellow line on Platform
Do not twist the chest bands
Maintain chest bands at 90 degrees to Platform and free of obstructions
1. Power up AutoPulse 2. Close chest bands
3. Press CONTINUE (green button) 4. Press START (green button) to begin compressions To pause or stop operation press STOP (orange button)
Follow all local protocols and procedures. Review User Guides and complete in-service training.
Troubleshooting For Fault/User Advisory • Lift up and fully extend both chest bands. • Check both lateral and vertical patient alignment. • Verify that chest bands are not twisted, are 90 degrees to the Platform and are free of obstructions. • Press RESTART (green button) and follow on-screen instructions to begin compressions. If you cannot rectify problem immediately open chest bands and revert to manual CPR. LifeBand® instructions on other side
P/N 10596-001 Rev. 10
AutoPulse® Quick Reference Guide
LifeBand® Load-distributing Band Removing LifeBand
2
• Place AutoPulse face down. • Lift hinged skirts, pinch 4 locking tabs and remove Cover Plate. • Grasp the Band with the thumb and index finger of both hands. 1 Push in the Guide Plate, using both middle fingers and, 2 pull up the Band to remove the clip from the shaft.
1
Installing new LifeBand • Match arrow on the Cover Plate with arrow on Platform. • 1 Insert Head end of Band Clip into slot. 2 Press Tail end of Band Clip into Guide Plate slot and feel for "click." Rotate shaft in either direction to verify Band Clip is seated in slot. Ensure that Band is not twisted.
Head End
1
Band Clip
LifeBand Cover Plate
• Snap Cover Plate in place and flip down hinged skirts.
Guide Plate
• Important: power on AutoPulse. If a Fault/User Advisory is displayed, check installation of the Band Clip into the Drive Shaft slot.
2
Tail End
AutoPulse deployment on other side Inquiries to: ZOLL Circulation 650 Almanor Avenue Sunnyvale, CA 94085 U.S.A. AutoPulse is a trademark of ZOLL Circulation ZOLL Circulation ©2009 Printed in U.S.A. P/N 10596-001 Rev. 10
t: +1.800.321.4CPR (4277) t: +1.408.541.2140 f: +1.408.541.1030
EU Authorized Representative ZOLL International Holding B.V. Newtonweg 18 6662 PV ELST The Netherlands t: +31 481 366410
0344